4.9 (563) · € 21.00 · En Stock
Trying to print miniatures, but prints consistently fail after 1-2 hours looking like this. What could be the problem? : r/FixMyPrint
Violent underextrusion - Believed to be heat creep but very unsure : r/ FixMyPrint
Under extrusion at the start of the layer : r/FixMyPrint
Wall lines not connecting end to end. Is this a problem caused by under extrusion? : r/FixMyPrint
Under extrusion after printing the first top layer : r/FixMyPrint
Sever under extrusion : r/FixMyPrint
Blob at perimeter start, followed by underextrusion : r/FixMyPrint
Underextruding with the Microswiss NG and Ender 3 Pro : r/FixMyPrint
What is causing all those bumps, under extrusion and ringing? White was printed 3 months ago, green was before tightening belts, and red is after. : r/FixMyPrint
Under extrusion without any change in parameters whatsoever : r/ FixMyPrint
What is causing all those bumps, under extrusion and ringing? White was printed 3 months ago, green was before tightening belts, and red is after. : r/FixMyPrint